Provides hardware SPI support.
More...
Provides hardware SPI support.
Instantiate hardware SPI object.
| virtual void SPIClass::begin |
( |
| ) |
|
|
virtual |
begin(): Initializes the SPI bus by setting SCK, MOSI, and SS to outputs, pulling SCK and MOSI low, and SS high.
Implements SPIBase.
| virtual void SPIClass::beginTransaction |
( |
SPISettings |
mySettings | ) |
|
|
virtual |
beginTransaction()
Initializes the SPI bus using the defined SPISettings
this methode does not initiate a transaction. So it can be used to setup the SPI after SPI.begin()
Implements SPIBase.
| virtual void SPIClass::end |
( |
| ) |
|
|
virtual |
end()
Method for compatibility with Arduino API. Provides NOP
Implements SPIBase.
| virtual void SPIClass::endTransaction |
( |
| ) |
|
|
virtual |
endTransaction()
Method for compatibility with Arduino API. Provides NOP
endTransaction(): Stop using the SPI bus. Normally this is called after de-asserting the chip select, to allow other libraries to use the SPI bus.
Implements SPIBase.
| uint8 SPIClass::read8 |
( |
| ) |
|
read8() read a byte from SPI without setting up registers
- Parameters
-
- Return values
-
| byte | received used for performance tuning when doing continuous reads
this method does not reset the registers , so make sure
that a regular transfer(data) call was performed
Note: this method is not found on the Arduino API
USE WITH CARE !! |
| virtual unsigned char SPIClass::transfer |
( |
unsigned char |
val | ) |
|
|
inlinevirtual |
transfer()
- Parameters
-
- Return values
-
calls private method transfer32(byte) to send/recv one uint32_t input/output casted to rightdta type
SPI transfer is based on a simultaneous send and receive: the received data is returned in receivedVal (or receivedVal16).
receivedVal = SPI.transfer(val) : single byte
receivedVal16 = SPI.transfer16(val16) : single short
Implements SPIBase.
| virtual void SPIClass::transfer |
( |
uint8 * |
buffer, |
|
|
size_t |
numberBytes |
|
) |
| |
|
virtual |
transfer(uint8 *buffer, size_t numberBytes)
- Parameters
-
| buffer | in/out |
| numberBytes | lenght of buffer |
SPI transfer is based on a simultaneous send and receive: The buffered transfers does split up the conversation internaly into 64 byte blocks. The received data is stored in the buffer passed by reference. (the data past in is replaced with the data received).
SPI.transfer(buffer, size) : memory buffer of length size
Implements SPIBase.
| virtual unsigned short SPIClass::transfer16 |
( |
unsigned short |
val | ) |
|
|
inlinevirtual |
transfer16()
- Parameters
-
- Return values
-
calls private method transfer32(byte) to send/recv one uint32_t input/output casted to rightdta type
SPI transfer is based on a simultaneous send and receive: the received data is returned in receivedVal (or receivedVal16).
receivedVal = SPI.transfer(val) : single byte
receivedVal16 = SPI.transfer16(val16) : single short
Implements SPIBase.
1.8.11